You should try to identify which type you have beforehand as this would alter the fixings that you use to fix into them. You may or may not know what is in your wall or you may have to begin work before you find out. There are two different types of studwork, wooden studs or metal studs. I also mention a couple other wall types at the end of this article. These are usually, but not always the exterior and load-bearing walls in your property. Dot and dab walls are very common in new-builds and buildings that have been recently renovated. There would be no point looking for studwork in this type of wall as there is none and different fixings will be required, like Corefix fixings. There is another type with modern building techniques that involves sticking plasterboard on top of brickwork or breezeblock, this is called a “dry-lined” wall or a “dot and dab” wall. There are various types of plasterboard wall, just because you have a plasterboard wall doesn’t mean that there will be studs inside of it. Pro Tip- On a measuring tape, there is a little arrow that indicates what the distance between studs should be. The noggins are usually about halfway up the wall and help strengthen it. The studs run vertical and often a horizontal timber piece in between called a noggin. This means once you have found one you can usually find the next one. It helps when securing into studs to know the distances between the studs, these are usually 16”(406mm) or 24”(610mm) apart when measured centre to centre of the studs, which are usually 2" apart. It is common for some form of insulation to be installed inside the stud wall to stop heat losses and/or soundproofing.įor a deeper explanation I recommend this Wikipedia article: In the UK a plaster skim is usually applied over the top, but is the US it is standard just to tape and skim between plasterboard joints. On top of the studs, sheets of plasterboard are fixed and screwed into the studs. Often there is a small, horizontal fixing piece in-between the studs called a noggin. A stud wall is constructed with vertical “studs”, usually made of timber(2x4) or metal which fix's between the floor and the ceiling. Although not always, these usually are not load bearing walls. A stud wall is usually a partition wall that divides a large space into smaller rooms. It helps before we begin discussing how to find and fix into stud walls, what they are and how they are constructed. In this blog, I discuss tips and offer advice for how to find the studs in your wall. Although there are plasterboard fixings that can be used to good for effect to install TV’s which are very lightweight nowadays, if you wanted to mount something heavier it may be essential to find the studs as this may be the only way that you can get a secure, safe fixing. If you wish to mount a TV or something similar onto a stud plasterboard wall, it’s helpful to find the studwork to get your wall fixings into as this will offer the most secure fixings.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |